The pre-installed connector fits small J-hook arms. Rotate the connector slightly to a 45-90 degree angle and align the J-hook around the connector. Slightly tug or pull back until you hear a “click.”
For large J-hook arms (measurement between the J-hook ½” or greater), replace the pre-installed connector with the connector provided in the wiper blade package.
Click here for hints. Rotate the connector slightly, align the J-hook around the connector and slightly tug until you hear a “click.”
Installation Instructions (1/4” and 3/16” pin) - Replace the pre-installed connector with the connector provided in the wiper blade package.
Click here for hints. Align your pin arm with the appropriate wiper blade frame hole. The smaller wiper blade frame hole fits 3/16” diameter pin arms and the larger frame hole fits ¼” diameter pin arms. Slide the wiper blade frame onto the pin arm until you hear a “click”. If pin will not slide easily, try rotating one side of adapter up and out of frame to about a 45 degree angle, slide pin through hole in frame, and rotate adapter back down over pin until it ‘clicks’ into place.
